It will take a few minutes, but once booted correctly, you'll get the following status screen. If you're using PiAware loaded on top of a Raspian image, please check below for alternative set up instructions. PiAware will then boot, and you'll be rewarded with the following splash. With the power supply plugged in, turn on the power supply. Once you have double checked everything has been connected properly, it’s time to plug in your micro usb power supply. The FlightAware dongle is quite large, so you'll likely find you need to use a USB extension cable in order to access the remaining USB sockets. So plug it all together as your setup dictates:įinally, we can plug in our keyboard & mouse (if you require them - if connecting via SSH see note at the end **). In this guide we'll be using a filter, and a large N-Type Antenna designed for external use. In some scenarios, the user will not need a filter, or want to omit the extension to filter cable, or the antenna may have a built in cable etc. However, the basic premise of plugging it all in is the same in almost all cases it will go:įlightAware Dongle > Extension Cable > Filter > Extension Cable > Antenna We've now got to plug in and set up our Antenna! There are quite a few different configurations of antenna e.g. If you are using a TV, make sure you have the correct input selected. Pi datalink 2013 install kit tv#The other end of the cable should be plugged into your TV or Monitor. This is located on the underside of the Pi. So first step is to safely eject your microSD card from your PC, and insert the micro SD card into the dedicated micro SD card slot on the Raspberry Pi. You're now ready to connect all your Raspberry Pi hardware together and get aircraft tracking! That's it! Once the process is complete your new operating system image is ready to use. Hit yes, and the image will burn to your card. You'll get a warning message to confirm that you're happy to proceed. When you're happy that you have the correct image, and correct device, hit write. The last thing you want to do is overwrite your computer's hard drive, so select the correct drive letter for your SD card! Win32 will pick up any removable media including SSD's. Now, insert your SD card into your laptop/computer and browse to the PiAware image file.īEFORE YOU HIT WRITE - Please make sure that you have selected the correct device. Pi datalink 2013 install kit software#There's one more piece of software we need to burn our image - Win32 Disk Imager. img (image) file, which is the PiAware operating system! We're now ready to copy your operating system image over to our SD card! Pi datalink 2013 install kit download#Once the download has complete, you'll need to extract the files from the download. Head over to the FlightAware PiAware build page, and download the latest image: Your SD card has now been formatted and is ready to load the PiAware software on to it. Now click the format button and click "OK" on the prompts. Once you have selected the drive letter, click on the "Options" button, and select "ON" from the "FORMAT SIZE ADJUSTMENT" dropdown. Make sure the correct drive letter for your SD card has been selected from the drop down. Plug your SD card into your computer and load up the SD Formatter software. If you haven't already got this software, you will need to download and install it. To do this, we will use a piece of software called SD Formatter, by SD Association. If you've already got a pre-loaded micro SD card then skip straight to Step 2!įirst we need to prepare our SD card. Our FlightAware set up kit comes with a 16GB micro-SD card pre-image with PiAware software! However, if you need to re-install the software for some reason, the steps to do so are outlined here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |